Мы выполнили 9 629 ремонтов.
У нас заправили 34 327 картриджей.
В каталоге 104 842 товара.
В наличии 63 781 товаров.

Купи лазерный принтер - получи первую заправку бесплатно.

Подробнее...

Инструкция по заправке принтеров HP 2015 (part 2) (язык английский)

Хотите что-бы заправили мы? Перезвоните по тел. 5024455.
Или оформите заявку
OnLine.

HP® MONOCHROME LASER PRINTER P2015


HP® P2015 LARGE HOPPER CONVERSION KIT
INSTRUCTIONSUNINET IMAGING INC.
8. Add a drop of glue in area shown, then place the trigger arm


9. Insert the Trigger arm locking pin to fix the
trigger in position. as shown on the photo

  

10. Fill Hopper with toner and insert the filler cap.
NOTE: The photo shows a UniNet 1320 Jumbo hopper (#11151)
with seal fitted. If you are using an OEM HP® 1320 hopper for this
conversion, make sure you disassemble the OEM Left/Right end
caps, Mag Roller, Mag Roller bushing, Mag Roller, Wipers, Doctor
Blade, and carefully clean all components thoroughly, except for
the end caps which are discarded.

11. Install the doctor blade into the Hopper, and place the Mag
Roller wiper on each end of the Doctor Blade. Tighten the two
screws (shown) that hold the doctor blade and wipers in place.


.

 


 
LARGE HOPPER CONVERSION KIT
INSTRUCTIONSUNINET IMAGING INC.
12. Place the Left/Right Mag Roller Bushing on each end of the

13. Install the Left Stabilizer on the P2015 Left End Cap as
Mag Roller. shown.

 


14. Now, install the Left End Cap onto the left side of the hopper.
The P2015 Left End Cap includes the Pull Tab feature
like the right side of the hopper. OEM but does not include
the orange clip. The orange clip is available separately or you
can use the OEM orange clip Tighten
all screws on the Left End Cap.



15. Install the Mag Roller as shown in the Hoper as
shown in the photo. Then insert the Right Stabilizer, and all
drive gears on the right side of the hopper.

 

16. Install the P2015 Right End Cap on the right side of the Hopper.
Tighten the 2 screws on the Right End Cap.

 


17. Assemble the Hopper side and Waste Hopper together and insert
the hinge pin on each side to hold them together.

  


18. Pin inserted on other side.


19. Finally, install the Chip, and the conversion from an
HP® 1320 cartridge to a cartridge that will fit the HP® P2015.
Conversion is complete.

part 1